If your garage door panel is damaged, don’t worry! In this blog post, we’ll walk you through the steps to repairing your garage door panel. We’ll also provide tips on how to prevent damage in the future.
So keep reading on!
Signs that Tell Your Garage Door Panel Needs a Repair
Before getting into the repairing process, let’s look at some signs that your garage door panel might need a repair. If you notice these signs, it’s time to take action!
- Your garage door is not opening or closing correctly.
- There is a gap between the garage door and the floor.
- The garage door panel is bent or dented.
- The garage door panel is cracked or broken.
- The paint on the garage door panel is peeling or chipping.
You should repair your garage door panel as soon as you notice any of these signs!
Tools You Need to Repair a Garage Door Panel
Before you begin, gather the following tools:
- A screwdriver
- A drill
- A measuring tape
- A hammer
- Replacement panels (if necessary)
3 Steps to Repairing a Garage Door Panel
Step 1: Remove the Damaged Panel
- Using a screwdriver, remove the screws holding the damaged panel.
- If the panel is severely damaged, you may need to use a power drill to remove the screws.
- Be careful not to damage the surrounding panels when removing the screws.
Step 2: Measure and Cut the Replacement Panel
- Using a measuring tape, measure the opening of the panel.
- Then, using a saw, cut the replacement panel to size.
- Make sure that the replacement panel is slightly smaller than the opening. It will allow for easy installation.
Step 3: Install the Replacement Panel
- Place the replacement panel into the opening.
- Using a hammer, gently tap the panel into place.
- Once the panel is in place, replace the screws you removed in step one.
- Tighten the screws until they are snug.
- Do not overtighten, as this could damage the panel.
Tips to Prevent Future Damage to Your Garage Door Panel
Here are a few tips to help you keep your garage door panel in good condition:
- Inspect your Garage Door Regularly: Check for signs of wear and tear, such as rust, dents, or cracks. If you notice any damage, take action immediately to prevent further damage.
- Clean Your Garage Door Regularly: Use a mild soap and water solution to clean the door. Avoid using harsh chemicals, as these can damage the finish on the door.
- Lubricate Your Garage Door: Once every three months, apply a lubricant to the moving parts of your garage door. It will help to reduce friction and prevent wear and tear.
- Replace Worn or Damaged Parts: If you notice that a part of your garage door is worn or damaged, replace it right away. Doing so will prevent further damage to the door and keep it operating smoothly.
How Difficult Is It to Repair Your Garage Door Panel on Your Own?
Most garage door experts recommend that you do not attempt to repair your garage door by yourself. Garage door panels can be seriously injured if not handled properly because of the tension created by the garage door spring. We suggest using this guide if you’re still up to the challenge but use extreme caution. You can hire Florida Garage Door Repair to help you repair your garage door panel if you cannot do it yourself.
Contact Us
These tips will help keep your garage door panel in good condition for years to come. However, if you want to get your garage door panel fixed through a professional team then Florida Garage Door Repair is a perfect match for the job. You can call us 24/7.